Catalog
Request Information
  • Advanced Heating and Hot Water Systems.
  • Commercial Gas Fired Water Heater.
  • Flexible Front and Rear Connections.
  • Built to Last Longer.
Unit of Measure

Specifications

Manufacturer

 N/A HTP®

Capacity

 N/A 65 gal

Input Power

 N/A 300000 BTU/hr

Inlet/Outlet (NPT)

 N/A 1.5 in

Shipping Weight

 N/A 465 lb

Type

 N/A Natural Gas

Available Kits

 N/A High altitude kits available for units installed at altitudes over 7000 feet.
  1. Vent Pipe
  2. Flue Damper / Draft Hood Assembly
  3. Hot Water Outlet
  4. Cold Water Manual shut-off Valve
  5. Temperature & Pressure Relief Valve
  6. Expansion Tank
  7. Overflow Tube
  8. Cold Water Inlet
  9. Cleanout Cover Access Door
  10. Drain Valve
  11. Drain Pan
  12. Free-Flowing Floor Drain
  13. Union
  14. Burner Assembly
  15. Gas Valve
  16. Union
  17. Cap
  18. Drip Leg (Sediment Trap)
  19. Gas Supply Manual Shut-off Valve
  20. Electric Box
  21. Aquastat / High Limit Control
  22. Union
  23. Temperature Sensor
  24. Flue Damper Motor
  25. Flue Damper Support Leg

Maximum Recovery (ºF)

Recovery at 100 ºF Temperature Rise

 N/A 290.9 gal/h

Dimensions

Schematic

 N/A
Schematic Drawing for HTP® Heavy Duty Commercial Gas Fired Water Heaters

Dimension A

 N/A 15-3/4 in40 cm

Dimension B

 N/A 52-1/8 in132 cm

Dimension C

 N/A 64-3/8 in164 cm

Dimension D

 N/A 6-3/8 in16 cm

Dimension E1

 N/A 25-1/4 in64 cm

Dimension E2

 N/A 58-1/4 in148 cm

Dimension E3

 N/A 25-1/4 in64 cm

Dimension E4

 N/A 58-1/4 in148 cm

Dimension F

 N/A 71-5/8 in182 cm

Dimension G

 N/A 33 in84 cm

Dimension H

 N/A 8 in20 cm

Dimension I

 N/A 26-1/2 in67 cm

Features

Features

 N/A
  • Blue Cobalt Glass-lined tank

    • Long lasting blue cobalt glass is fused to specially formulated steel at 1,600 ºF to provide the best coating available against corrosion. The tank is certified at a test pressure of 300 PSI and a working pressure of 150 PSI.
  • Multi-port, energy efficient burners

    • Quiet Burner! The burner tray slides out easily for quick inspection & easy maintenance.
  • Low profile automatic flue damper

    • Closes automatically when the demand for heat stops, reducing stand-by heat loss.
  • High density insulation.
  • Automatic temp control system

    • The thermostat is fully adjustable up to 180 ºF. It is equipped with an integrated energy cutoff (ECO) and high temperature cut-off switch to protect against overheating.
  • Factory installed T&P relief valve.
  • Spark to pilot ignition system.
  • Intelligent led diagnostic system

    • Designed to give a visual indication of the operational status of the water heater. This panel also identifies where to begin troubleshooting a non-functional water heater.

More Steel Where It Counts

More Steel Where It Counts

 N/A Every commercial gas water heater endures constant day-to-day stress due to frequent changes in temperature. Critical stress points are located where tank components are welded - most notably at the flue tubes and where the tank bottom joins the tank. HTP® has made these stress points much more leak resistant thru design, extra thick steel and special welding techniques.

The largest steel collar used in the industry is welded from outside of the tank bottom and top, permitting stronger welding of the flue tubes. The tank bottom and top and the flue tubes are glass-lined separately with an industrial grade coating of a blue cobalt glass.

The refractory combustion chamber is insulated entirely with 3/4" of ceramic fiber. This feature permits better heat retention in the combustion chamber, translating into a higher heat exchange to the water.

What's in the Box

What's in the Box

 N/A
  • Low Profile Automatic Flue Damper
  • Intelligent LED Diagnostic System
  • T&P Relief Valve
  • Installation Manual

Standard Features

Standard Features

 N/A
  • High Density Insulation
  • Multi-Flue Design
  • Clean Out & Inspection Port
  • Multi-Port Efficient Burners with Slide Out Tray for Easy Inspection
  • Blue Cobalt Glass Lined
  • Type B Venting
  • 5-Year Limited Warranty if Registered Online

Optional Equipment

Optional Equipment

 N/A
  • Power vent and aluminum vent hood mounts on outside of wall. Rust-Free construction, condensate shield, heat shield, mounting hardware

Warranty

Warranty

 N/A
  • 5-Year Limited Warranty.

Note

Note

 N/A Models of 125,000 and 150,000 Btuh and their derated versions can also use a 1/2" gas connection.